Ball Hone – 24″

Description

G3 Cetme Ball Hones –  24’’

Our custom silicon carbide Ball hone for cleaning up your cocking tube weld areas and inside the top section of the receiver after scope rail welding or rear sight welding.  Anybody who has done this job will love this tool. They can be trimmed to custom lengths for your application. Hand Drill use only. Never used this in a die grinder! They spin 20,000-30,000 rpm!   It was never designed to do this. It will bend and could be dangerous for you and your project.  Run them soaked in oil!

• 18.25mm
• 18.00mm
• 20.00 mm

All ATF / NFA rules apply to purchases made from this site. It is the sole responsibility of the purchaser to know and understand all applicable Federal, State, and local laws before placing an order. By placing any order, you are agreeing that you accept all legal responsibility for the products purchased and their subsequent use.